Use and Care Manual

14 ENGLISH
1
►1. Release button
CAUTION: After changing the bevel angle,
always secure the saw head by turning the lever
upward rmly.
NOTICE: When tilting the saw blade, be sure the
handle is fully raised.
NOTICE: When changing bevel angles, be
sure to position the kerf boards appropriately
as explained in the "Positioning kerf boards"
section.
Setting 46° bevel angle
1. Loosen the lever and tilt the blade to the left or
right fully.
1
►1. Lever
2. Totiltthebladetotheleft,holdthehandleandtilt
the saw head to the right slightly, and then move the
releaselevertothedirectionofthearrow.Thebevel
anglecanbeadjustedbetween45°to46°bytiltingthe
saw head while moving the release lever.
Totiltthebladetotheright,holdthehandleandtiltthe
saw head to the left slightly, and then move the release
levertothedirectionofthearrow.Thebevelanglecan
beadjustedbetween45°to46°bytiltingthesawhead
while moving the release lever.
1 2
►1. Lever 2. Release lever
3. Turntheleverupwardrmlytosecurethesaw
head.
Adjusting the lever position
If the lever does not provide full tightening in course of
time,changethepositionofthelever.Thelevercanbe
repositioned at every 30° angle.
Loosen and remove the screw that secures the lever.
Remove the lever and install it again so that it points
slightlyabovethehorizontal.Then,tightenthelever
withthescrewrmly.
1 2
►1. Lever 2. Screw