Use and Care Manual

18 ENGLISH
1
2
2
►1. Saw blade 2.Arrow
2. Installtheouterangeandhexsocketbolt,and
then use the hex wrench to tighten the hex socket bolt
(left-handed) of the spindle securely counterclockwise
while pressing the shaft lock.
3. Return the blade guard and center cover to its
originalposition.Thentightenthehexsocketboltofthe
center cover clockwise to secure the center cover.
4. Release the handle from the raised position by
pulling the stopper pin. Lower the handle to make sure
that the blade guard moves properly.
5. Make sure the shaft lock has released spindle
before making cut.
Dust bag
Theuseofthedustbagmakescuttingoperations
cleaner and dust collection easier.
Toattachthedustbag,titontothedustnozzle.
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty
the dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper further collection.
1
2
3
►1. Dust bag 2. Dust nozzle 3. Fastener
NOTE: If you connect a vacuum cleaner to your saw,
cleaner operations can be performed.
Securing workpiece
WARNING: It is extremely important to always
secure the workpiece correctly with the vise.
Failuretodosomayresultinseriouspersonalinjury
and cause damage to the tool and/or the workpiece.
WARNING: When cutting a workpiece that
is longer than the support base of the saw, the
material should be supported the entire length
beyond the support base and at the same height
to keep the material level. Proper workpiece support
will help avoid blade pinch and possible kickback
whichmayresultinseriouspersonalinjury.Donot
rely solely on the vertical vise and/or horizontal vise
tosecuretheworkpiece.Thinmaterialtendstosag.
Support workpiece over its entire length to avoid
bladepinchandpossibleKICKBACK.
1
2
►1. Support 2.Turnbase
Vertical vise
WARNING: Secure the workpiece rmly
against the turn base and guide fence with the
vise during all operations.Otherwisethematerial
may move during the cutting operation, cause dam-
age to the blade, and be thrown which may result in
lossofcontrolandseriouspersonalinjury.
Install the vertical vise on either the left or right side of
the guide fence. Insert the vise rod into the hole in the
guide fence and tighten the lower screw to secure the
vise rod.