Use and Care Manual

22 ENGLISH

►1. Guide fence 2. Hex socket bolt

5. Lower the handle fully and lock it in the lowered

position by pushing in the stopper pin.

6. Adjusttheguidefenceuntilitmakesaperpendic-

ular angle with the blade using a triangular rule, try-

square,etc.Thensecurelytightenthehexsocketbolt

on the guide fence.

12 3

►1. Guide fence 2.Triangularrule3. Saw blade

7. Make sure that the pointer indicates 0° on the

miter scale. If the pointer does not indicate 0°, loosen

thescrewwhichsecuresthepointerandadjustthe

pointer so that it indicates 0°.

►1. Screw 2. Miter scale 3. Pointer

Bevel angle

0° bevel angle

1. Lower the handle fully and lock it in the lowered

position by pushing in the stopper pin.

2. Loosen the lever at the rear of the tool.

3. Turnthe0°bevelangleadjustingboltontheright

side of the saw head two or three revolutions counter-

clockwise to tilt the blade to the right.

►1.Adjustingbolt2. Lever

4. Turnthe0°bevelangleadjustingboltclockwise

carefully until the side of the blade makes a perpendic-

ular angle with the top surface of the turn base. Use the

triangularrule,try-square,etc.asaguide.Thentighten

the lever securely.

►1.Triangularrule2. Saw blade 3.Topsurfaceof

turn table