Use and Care Manual

24 ENGLISH

►1. Vise

5. Install the battery cartridge to the tool and turn on

the laser switch.

6. Loosentheadjustingscrew.Tomovethelaserline

awayfromtheblade,turntherangeadjustmentscrews

counterclockwise.Tomovethelaserlineclosetothe

blade,turntherangeadjustmentscrewclockwise.

Adjusting the laser line on the left side of the blade

►1.Adjustingscrew2.Rangeadjustmentscrew

3. Hex wrench 4. Laser line 5. Saw blade

Adjusting the laser line on the right side of the

blade

►1.Rangeadjustmentscrew2. Hex wrench 3. Laser

line 4. Saw blade

7. Slidetheadjustingscrewtothepositionthatthe

laser line comes onto the cutting line and then tighten.

NOTE:Themovablerangeoflaserlineisfactory

adjustedwithin1mm(0.04")fromthesidesurface

of blade.

Cleaning the laser light lens

Thelaserlightbecomeshardtoseeasthelensfor

the laser light gets dirty. Clean the lens for laser light

periodically.

Remove the battery cartridge. Loosen the screw and

pull out the lens. Clean the lens gently with a damp soft

cloth.

►1. Screw