Use and Care Manual

13 ENGLISH

►1.Trimmerbit2. Workpiece 3. Straight guide

NOTICE: Since excessive cutting may cause

overload of the motor or difculty in controlling

the tool, the depth of cut should not be more than

3 mm (1/8") at a pass when cutting grooves. When

you wish to cut grooves more than 3 mm (1/8") deep,

make several passes with progressively deeper bit

settings.

Using the straight guide

Optional accessory

1. Assemblethestraightguidewiththeboltandthe

wing nut.

►1. Bolt 2. Wing nut

2. Attachthestraightguidetothetrimmerbasewith

the clamp screw.

►1. Clamp screw

3. Loosen the wing nut on the straight guide and

adjustthedistancebetweenthebitandthestraight

guide.Atthedesireddistance,tightenthewingnut.

►1. Wing nut

4. Movethetoolwiththestraightguideushwiththe

side of the workpiece.

Ifthedistance(A)betweenthesideoftheworkpiece

and the cutting position is too wide for the straight

guide, or if the side of the workpiece is not straight, the

straight guide cannot be used.

Inthiscase,rmlyclampastraightboardtothework-

piece and use it as a guide against the trimmer base.

Feed the tool in the direction of the arrow.