Use and Care Manual

12 ENGLISH

2. Close the lock lever.

Toremovethebase,followtheinstallationprocedure

in reverse.

Installing or removing the parallel

ruler on the plunge base

Optional accessory

Insert the guide bars into the holes in the plunge base,

andthentightenthewingbolts.Toremovetheruler,

follow the installation procedure in reverse.

►1. Wing bolt 2. Guide bar

Installing or removing the dust

nozzle on the plunge base

Insert the dust nozzle into the plunge base so that the

protrusiononthedustnozzletsinthenotchinthe

plunge base, and then tighten the thumb screw on the

dustnozzle.Toremovethenozzle,followtheinstalla-

tion procedure in reverse.

►1. Protrusion 2. Dust nozzle 3.Thumbscrew

OPERATION

Using the tool with the trimmer base

Set the tool base on the workpiece without the trimmer

bitmakinganycontact.Turnthetoolonandwaituntil

the bit attains full speed. Move the tool forward over

theworkpiecesurface.Keepthetoolbaseushwhile

moving the tool.

When cutting the edge, be sure to keep the workpiece

surface on the left side of the trimmer bit in the feed

direction.

NOTE: Before cutting on the actual workpiece, it is

recommendedtomakeasamplecut.Theproperfeed

speed depends on the bit size, the kind of workpiece,

and depth of cut. Moving the tool forward too fast may

cause a poor quality of cut, or damage to the bit or

motor. Moving the tool forward too slowly may burn

and mar the cut.

When using the trimmer shoe, the straight guide, or the

trimmer guide, be sure to keep it on the right side in the

feeddirection.Thiswillhelptokeepitushwiththeside

of the workpiece.