Use and Care Manual

17 ENGLISH
1
2
3
4
►1. Wing bolt 2. Guide holder 3. Wing nut 4. Straight
guide
2. Loosen the wing nut on the straight guide and
adjustthedistancebetweenthebitandthestraight
guide.Atthedesireddistance,tightenthewingnut.
1
►1. Wing nut
3. Operate the tool in the same way as the straight
guide for the trimmer base.
Using the templet guide
Optional accessory
1. Loosen the screws on the base and remove them.
Place the templet guide on the base, and then tighten
the screws.
1
2
►1. Screw 2.Templetguide
2. Operate the tool in the same way as the templet
guide for the trimmer base.
Using the parallel ruler
Theparallelruleriseffectivelyusedforstraightcuts
whenchamferingorgrooving.Adjustthedistance
betweenthebitandtheparallelruler.Atthedesired
distance, tighten the wing bolts to secure the parallel
ruler. When cutting, move the tool with the parallel ruler
ushwiththesideoftheworkpiece.
Ifthedistance(A)betweenthesideoftheworkpiece
and the cutting position is too wide for the parallel ruler,
or if the side of the workpiece is not straight, the parallel
ruler cannot be used.
Inthiscase,rmlyclampastraightboardtothework-
piece and use it as a guide against the plunge base.
Feed the tool in the direction of the arrow.