Use and Care Manual
12 ENGLISH
2. Close the lock lever.
Toremovethebase,followtheinstallationprocedure
in reverse.
Installing or removing the parallel
ruler on the plunge base
Optional accessory
Insert the guide bars into the holes in the plunge base,
andthentightenthewingbolts.Toremovetheruler,
follow the installation procedure in reverse.
1
2
►1. Wing bolt 2. Guide bar
Installing or removing the dust
nozzle on the plunge base
Insert the dust nozzle into the plunge base so that the
protrusiononthedustnozzletsinthenotchinthe
plunge base, and then tighten the thumb screw on the
dustnozzle.Toremovethenozzle,followtheinstalla-
tion procedure in reverse.
1
2
3
►1. Protrusion 2. Dust nozzle 3.Thumbscrew
OPERATION
Using the tool with the trimmer base
Set the tool base on the workpiece without the trimmer
bitmakinganycontact.Turnthetoolonandwaituntil
the bit attains full speed. Move the tool forward over
theworkpiecesurface.Keepthetoolbaseushwhile
moving the tool.
When cutting the edge, be sure to keep the workpiece
surface on the left side of the trimmer bit in the feed
direction.
NOTE: Before cutting on the actual workpiece, it is
recommendedtomakeasamplecut.Theproperfeed
speed depends on the bit size, the kind of workpiece,
and depth of cut. Moving the tool forward too fast may
cause a poor quality of cut, or damage to the bit or
motor. Moving the tool forward too slowly may burn
and mar the cut.
When using the trimmer shoe, the straight guide, or the
trimmer guide, be sure to keep it on the right side in the
feeddirection.Thiswillhelptokeepitushwiththeside
of the workpiece.