Use and Care Manual

9 ENGLISH
1
2
3
4
5
►1. Shaft lock 2. Loosen 3.Tighten4. Wrench
5. Collet nut
1
2
3
1
4
►1. Wrench 2. Loosen 3.Tighten4. Collet nut
NOTE:Theshaftlockmaynotreturntotheoriginal
position when you tighten the collet nut at the instal-
lationofthetrimmerbit.Theshaftlockreturnstothe
original position when you start the tool.
1
►1. Shaft lock
Installing or removing the trimmer
base
1. Open the lock lever of the trimmer base, then
insert the tool into the trimmer base aligning the groove
on the tool with the protrusion on the trimmer base.
1
►1. Lock lever
2. Close the lock lever.
3. Attachthedustnozzletothetrimmerbase,and
then tighten the thumb screw.
1
2
►1. Dust nozzle 2.Thumbscrew
Toremovethebase,followtheinstallationprocedure
in reverse.