Instructions / Assembly
Table Of Contents
- 1 CONTENTS
- 2 CAUTION
- 3 NECESSARY REPAIRING TOOLS
- 4 FASTENING TORQUE
- 5 LUBRICANT AND ADHESIVE APPLICATION
- 6 REPAIR
- 7 CIRCUIT DIAGRAM
- 8 WIRING DIAGRAM
26 / 41
Cover
Rib A
Sub controller complete
(without Switch)
Put Tape B in left or right groove as shown below.
Don’t put any Lead wires on this Rib.
Boss
Don’t route any Lead wires under Sub
controller complete (without Switch).
Put Tape A in this space.
Put two Connectors Sub controller complete (both with Switch
and without Switch) in this space as shown above.
Tape B
Tape A
Don’t put any Lead wires on this Cover.
Sub controller complete (with Switch)
Lead wires of Sub controller complete (without Switch)
must be tight. Don’t make a slack between Tape A and Tape B.
・
Tape A , Tape B: Sub controller complete (without Switch) for bundling Lead wire
Lead wire connected to Sub controller complete (without
Switch) between Boss and Rib A.