Installation Guide
Table Of Contents
- 1 CONTENTS
- 2 CAUTION
- 3 NECESSARY REPAIRING TOOLS
- 4 FASTENING TORQUE
- 5 LUBRICANT AND ADHESIVE APPLICATION
- 6 REPAIR
- 7 CIRCUIT DIAGRAM
- 8 WIRING DIAGRAM
24 / 41
8-1-3 Assembling of other than Power supply cord
Put Electrolytic capacitor
in this space.
Put Controller lead wire connected to Electrolytic capacitor and
Lead unit (for connecting to Key) one of Lead holder one by one.
Lead wire must be tight in Controller side. Don’t make a slack
around Lead holder.
Put Lead wires in the below area to avoid pinching.
・between Cover and Lead unit (for connecting Key)
・between Cover and Center case
Lead unit (for connecting to Key)
Cover
Put Closed end splice connected
to Lead unit (for connecting to Key)
in this space.
<Area A>
<Area B>
<Assembling of Area A>
Fig.：Drawing after repair
Electrolytic capacitor
Don’t put any Lead wires
on this Rib.