Installation Guide
Table Of Contents
- 1 CONTENTS
- 2 CAUTION
- 3 NECESSARY REPAIRING TOOLS
- 4 FASTENING TORQUE
- 5 LUBRICANT AND ADHESIVE APPLICATION
- 6 REPAIR
- 7 CIRCUIT DIAGRAM
- 8 WIRING DIAGRAM
27 / 41
Route Lead wires in this area not to be floated up to Face A.
・Lead wire connected to Sub controller complete (without Switch)
・Controller lead wire passed through Line filter A
Sub controller complete (with Switch)
Avoid pinching of Lead wires under Sub controller
complete (with Switch)
Face A
<Assembling of Area B>
Line filter A
(
with Controller, without Tube)
Put Line filter A as shown below (left side of Hook)
Hook
Sub controller complete
(without Switch)
Controller case
A
A’
Avoid pinching of Lead wires between Line filter A and
Center case, Controller case.
The cross section between A – A’
Controller case
Rib of Center case
Rib of Center case
Line filter A