Installation Guide

28 / 41
8-1-4 Assembling of Power supply cord
Cord for LED light
Relay cord
for Switch box
Cord for Brake
Cord for Motor
Route Lead wires connected
to Relay cord for Switch
box
between Ribs.
Rib
Put Controller lead wires (connecting Relay cord for Switch
box) connected to Closed end splice into either Lead holder
one by one.
Don’t make a slack at Controller side near Lead holder.
10 pins
Put Connector of Relay cord for Switch box in this space as shown below.
<
Assembling of
Relay cord for Switch box and Cord for LED light
>
Fig.
：
Drawing after repair
4 pins
Relay cord
for Switch box
Put Closed end splice of which
Lead wires are connected to Relay
cord for Switch box in the below
dot area.
Pass-through slot