Installation Guide
Table Of Contents
- 1 CONTENTS
- 2 CAUTION
- 3 NECESSARY REPAIRING TOOLS
- 4 FASTENING TORQUE
- 5 LUBRICANT AND ADHESIVE APPLICATION
- 6 REPAIR
- 7 CIRCUIT DIAGRAM
- 8 WIRING DIAGRAM
33 / 41
8-3 LED Light case section
Line filter (with LED circuit)
Route Lead wire of LED circuit
through this groove.
LED circuit
Assemble Power supply cord unit
(with two Connectors) at this side.
< Right side >
Assemble the tip of Sheath of Power supply
cord (with two Connectors) in this zone.
Don’t make a slack in
this space.
<
Left side
>
Line filter ( with LED circuit)
Assemble the tip of Sheath of Power supply cord (with
a Connector) in this zone.
Don’t make a slack in
this space
Route Lead wire of LED
circuit through this groove.
Assemble the tip of Sheath of Power supply cord
(with a Connector) in this zone.
Assemble Power supply cord unit
(with a Connector) at this side.
Assemble Power supply cord unit
(with a Connector) at this side.
LED circuit
Don’t put any Lead
wires on this Rib.
Don’t put any Lead
wires on this Rib.