Use and Care Manual

9 ENGLISH
Mounting the attachment pipe
Mount the attachment pipe to the power unit.
1. Turnthelevertowardthecuttingattachment.
1
►1. Lever
2. Alignthepinwiththearrowmarkandinsertthe
attachment pipe until the release button pops up.
1
2
3
►1. Release button 2.Arrowmark3. Pin
3. Turnthelevertowardthepowerunit.
1
►1. Lever
Make sure that the surface of the lever is parallel to the
pipe.
Toremovethepipe,turnthelevertowardthecutting
attachment and pull the pipe out while pressing down
the release button.
Fig.12
3
1
2
►1. Release button 2. Lever 3. Pipe
Adjusting the handle/hanger
position
Adjustthehandleandhangerpositiontoobtainconfort-
able handling of the tool.
Loosenthehexsocketheadboltonthehandle.Move
the handle to a comfortable working position and then
tighten the bolt.
1
2
►1. Handle 2.Hexsocketheadbolt
Loosenthehexsocketheadboltonthehanger.Move
the hanger to a comfortable working position and then
tighten the bolt.
2
1
►1.Hexsocketheadbolt2. Hanger