User's Manual

6
2.3 Power cable
When the X3M/EasyLocator is mounted on the antenna connect the Power
cable from your battery.
Look for the countersink and place it
towards the mark on the connection.
Push lightly. If you have it in the correct
position it should connect smoothly.
To disconnect: Pull out, holding the milled
part of the connection.
2.4 Distance measuring devices
The X3M/EasyLocator can be used together with
the standard MALÅ GeoScience distance
measuring devices (hip-chain and measuring
wheels). The encoder cable is connected as shown
below (Figure 2.4)
2.5 Connection to computer
Add the computer to the system by
connecting the parallel port cable between
the computer and the X3M/EasyLocator
(Figure 2.5).
Use an IEEE 1284 compatible parallel cable
that is less than or equal to three meters
long.
Figure 2.4. Encoder
Figure 2.3. Power cable
Figure 2.5. Parallel port