User's Manual

www.malags.com
39
11.1 Connecting the system components
?? Mount the antenna electronics to the antenna element
according to Chapter 4 - 6.
?? Connect the CUII (labeled LPT 1) to the external PC
parallel port with the parallel data cable provided with
the system.
?? Connect appropriate fibre optic cables between the CUII
and the antenna electronics as follows:
?? For unshielded systems: Single fibre optic cable
from the fibre optic connector labeled T on the
CUII to the Transmitter Electronics. Dual fibre
optic cable from the fibre optic connectors
labeled D and R to their respective connectors on
the Receiver Electronics
?? For shielded systems: Fibres labeled T, D and R
should be attached to their respective fiber optic
connectors on the CUII.
NOTE: It is essential to attach the strain relief to the CUII in
order to protect the optical fibers and connectors. Failure to do
so will likely result in damaged cables.
?? Attach the appropriate Measuring Device (if any
purchased) and connect to the port labeled ENC.
?? Turn on the power on the antenna electronics and the
CUII. Turn on the PC and start the data acquisition
program GroundVision. Your RAMAC/GPR system is
now ready for operation.