Condenser Tumble Dryer TD 800 Owner’s Manual e nc l T! a N l TA rform d a e R PO t pe r e a efor IM s be y e r , ns b .
CONTENTS IMPORTANT SAFETY INSTRUCTIONS DESCRIPTION OF THE MACHINE INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTIONS REVERSING THE DOOR HINGES INSTRUCTIONS FOR USING THE TUMBLE DRYER CARE LABEL INSTRUCTIONS THE CONTROL PANEL RECOMMENDED PROGRAMS AND TEMPERATURE SETTINGS CARE AND MAINTENANCE INSTRUCTIONS CLEANING THE CONDENSER TROUBLESHOOTING QUICK START REFERENCE GUIDE 2 3 4 5 6 7 8 9 10 11 12 13 14 15
IMPORTANT SAFETY INSTRUCTIONS WARNING! To reduce the risk of fire, electric shock, or injury to persons when using your appliance, read the IMPORTANT SAFETY INSTRUCTIONS below: ♦ Read all instructions before using the appliance. ♦ Do not wash or dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaning solvents, cooking oils, other flammable or explosive substances as they give off vapors that could ignite or explode.
DESCRIPTION OF THE MACHINE ♦ The tumble dryer is constructed in sheet steel panels with a treated and painted finish that ensures its aesthetic quality remains unaltered over time. ♦ The motor and all moving parts are designed to guarantee minimum noise levels. ♦ The stainless steel drum is large and well mounted to ensure a better quality tumble dryer and a longer life of clothing. ♦ The control panel lets you use all the drying programs with ease.
INSTALLATION INSTRUCTIONS Read these instructions carefully before you install the machine. The installation should be carried out by a qualified person who is familiar with all local codes and ordinances for electrical connections. Incorrect installation may cause damage and/or injury. If the integrity of the machine is in doubt, do not use it. Call your dealer for qualified assistance. The dryer can be installed in any room with a hard floor. Do not install it on carpeting with heavy pile.
ELECTRICAL CONNECTIONS The power supply cord must be grounded. If the machine is to be used in a wet area, the supply must be protected by a residual current device. Connection to a permanently wired supply point must be made only by a qualified electrician. As supplied: Single-phase, 240 V, 60 Hz, 2500 Watt heater rating, 30 A fuse required CONNECTING A 3-WIRE POWER CORD WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box.
REVERSING THE DOOR HINGES The door on your Malber dryer is delivered to open from the right, but you can reverse the hinges so that it opens from the left. To do this, follow the steps below: 1. Unplug the dryer from the electrical outlet. 2. Supporting the door, remove the bottom left hinge then slide door down and off. 3. Remove the plastic plugs from the right side (A), top and bottom, by pressing the bottom edge of the plug with a screwdriver. Be careful not to scratch the surface of the machine. 4.
INSTRUCTIONS FOR USING THE TUMBLE DRYER OPENING THE DOOR Fig. 1 The tumble dryer has a magnetic door catch. To open it, press firmly on the opening side and release (Fig. 1). The door should pop open. GENERAL INSTRUCTIONS Below are some general operation instructions. For more detailed information, refer to pages 10 and 11. 1. Make sure the lint filter is free of lint (see page 12). 2.
CARE LABEL INSTRUCTIONS Most clothes and other washable items have permanent care labels. Read these labels carefully! Care label instructions and warnings should be followed for the best cleaning results. The table below defines the typical symbols used on fabric care labels. (Note: Some manufacturers may use slightly different symbols.
THE CONTROL PANEL The control panel on your Malber tumble dryer is easy to understand and simple to operate. Simply turn the control knob clockwise to the desired setting, select the program temperature (delicate or normal ), and press the ON/OFF button. START OFF 20' STOP 40' 60' NORMAL DELICATE TD 800 ON/OFF BUTTON AND LIGHT Press this button to turn the power to the machine on and off. When the power is turned on, the ON/OFF light will flash briefly and a tone will sound.
ANTI-CREASE If the Program knob is not turned to the stop position or the door is not opened at the end of a program, the Anti-crease function begins. This means that the drum rotates the clothes once every minute to prevent creases from setting in. The Anti-crease and end-of-program tone continue until you turn the Program knob to the stop position or open the door to remove the laundry. END-OF-PROGRAM TONE At the end of a program, the On/Off light flashes and a tone sounds.
CARE AND MAINTENANCE INSTRUCTIONS The tumble dryer does not require special care. To best ensure a long life, however, certain precautions are recommended (see also page 3). CLEANING THE LINT FILTERS To ensure proper circulation in your tumble dryer and minimize drying times, you should clean the lint filter after every load. To do this, follow the instructions below: 1. Remove the filter on the door from its holder by pulling it upwards (Fig. 1). 2. Gently run your hand across it to collect the lint.
CLEANING THE CONDENSER The condenser should be cleaned about once a month. If you have pets, you should probably clean it more often. To clean the condenser, follow the steps below: 1. Open the door to access the condenser. 2. Turn the levers on the condenser cover to a vertical position and lift the cover off (Fig. 1). 3. Turn the three levers on the condenser to a vertical position and remove the condenser by grasping the handle and pulling forward (Fig. 2). 4.
TROUBLESHOOTING Before calling for technical assistance, check that the operations described below have been carried out correctly. This will save both time and money. The machine wont start. Make sure the door is closed securely and nothing is caught between the door and the door opening. Make sure you pressed the ON/OFF button. Make sure the ON/OFF indicator light is on.
QUICK START REFERENCE GUIDE (Refer to pages 10 and 11 for more operating instructions.) Light Drain Light Light This light stays lit when the Normal setting is selected. It flashes to indicate the setting is Delicate. This light flashes and the dryer stops if the water tank is full. Empty the tank then press the Drain button until the light stops flashing. Reset the program. When the power is turned on, this light flashes briefly and a tone sounds.
4613055671 2 18/03/05 Litograf s.r.l.