User Guide

www.malcotools.com
Place the FasGroov #3 Tool against the slide
edge and push along to produce a left hand shi-
plap groove.
#3 TOOL
Move the FasGroov Square to the right and
measure the desired inside duct width dimension
(W2). Align with the right edge of cut previ-
ously made by the FasGroov #3 Tool. Place the
FasGroov #2/4 Tool against the slide edge and
push along to produce a second right hand shi-
plap groove.
Move the FasGroov Square to the right one last
time and measure the desired inside duct height
dimension (H2). Align dimension with the right
edge of cut previously made by the FasGroov
#2/4 tool. Place the FasGroov #5 Tool against
the slide edge and push along to produce a staple
flat groove.
Place the FasGroov Duct Knife on the right edge
of cut previously made by the FasGroov #5 Tool.
Cut completely through the foil to finish the
grooving process.
Fold the duct section together. Staple and tape
the duct section with manufacturer approved
products.
10