User Guide

www.malcotools.com
Place the FasGroov-Vee Tool against the slide
edge and push along to produce another vee
groove.
Move the FasGroov Square to the right and
measure the desired inside duct width dimension
(W2). Align dimension with the right edge of
vee groove made in the previous step. Place the
FasGroov-Vee Tool against the slide edge and
push along to produce a third vee groove.
Move the FasGroov Square to the right ,one last
time and measure the desired inside duct height
dimension (H2). Align dimension with the right
edge of cut previously made by the FasGroov-
Vee Tool.
Place the Fasgroov #5 Tool against the slide
edge. make sure the blade is turned the proper
way or in the proper set of holes to produce a
staple flap groove in the right handed vee groove
direction. For blade removal/replacement, see
page 14. Push along to produce a staple flap
groove.
#5 TOOL
Place the FasGroov Duct Knife on the right edge
of cut previously made by the FasGroov #5 tool.
Cut completely through the foil to finish the
grooving process.
Fold the duct section together. Staple and tape
the duct section with manufacturer approved
products.
12