Instructions / Assembly

Malibu Wide

Plank

Wall Installation

Instructions

Malibu Wide Plank

WALL INSTALLATION INSTRUCTIONS

READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION. If the following instructions

leave any unanswered questions or if additional information is required, please call Malibu Wide Plank toll free at

844-658-4700.

MATERIAL SHOULD BE INSPECTED PRIOR TO INSTALLATION

Responsibility for the suitability of Malibu Wide Plank products for each individual installation cannot be assumed by

Malibu Wide Plank since Malibu Wide Plank has no control over the installer’s proper application. Should an

individual plank be doubtful as to appearance or dimension the installer should not use this piece.

PRE-INSTALLATION JOBSITE REQUIREMENTS

Malibu Wide Plank cannot be held responsible for site conditions.

Carefully examine the material prior to installation for grade, color, finish, and quality. Ensure adequate lighting for proper

inspection. If material is not acceptable, contact your supplier immediately and arrange for replacement. Malibu Wide

Plank cannot accept responsibility for material installed with visible defects. Prior to installation of any material, the

installer must ensure that the job site and walls meet the requirements of these instructions. Malibu Wide Plank is not

responsible for material failure resulting from unsatisfactory jobsite and/or subfloor conditions.

Wall paneling/planks should be one of the last items installed in any new construction or remodel project. All work

involving water or moisture should be completed before material installation.

Room temperature and humidity of installation area should be consistent with normal, year-round living conditions for at

least one week before installation of material. Optimum room temperature of 70° F and a humidity range of 30% - 50% is

recommended during installation. Humidity levels below 30% will most likely cause movement in the material, including

gapping between pieces and possible cupping and checking in the face.

Store the material in the installation area before installation to allow material to adjust to room temperature. Do not store

the boxes of material directly on concrete. When installing in a properly acclimated environment,(65-75 degrees and

30%-50% relative humidity) material does not need additional acclimation. Shuffle the boards from several cartons for

best visual mix of lengths and color.

Phone: 844-658-4700

ATTENTION! READ BEFORE INSTALLING!

COLOR VARIATION

This is a natural product and color variations are to be expected. For best visual effect, shuffle

planks from several cartons and do not install boards varying greatly in color next to one another.

WALL PREPARATION

Wall should be smooth, in good condition, and relatively straight and plumb with minimal

bowing or curving of wall. Masonry walls and exterior walls should be moisture proofed prior to

applying planks to walls.

PAGE 1
Malibu Wide Plank Wall Installation Instructions ATTENTION! READ BEFORE INSTALLING! COLOR VARIATION This is a natural product and color variations are to be expected. For best visual effect, shuffle planks from several cartons and do not install boards varying greatly in color next to one another. WALL PREPARATION Wall should be smooth, in good condition, and relatively straight and plumb with minimal bowing or curving of wall.
PAGE 2
INSTALLATION TOOLS For all installation methods: • Tape measure • Tapping block (trimmed piece of flooring) • Pencil • Pry bar or pull bar • Chalk line • Crosscut power saw • Air stapler/nailer compatible with profile of the flooring material • 1 ½” – 2” nail, cleat, or staple that is compatible with the profile of the flooring material • Air compressor • Construction mastic for glue installation GLUE INSTALLATION If walls are in moderately good condition, construction mastic is usually the easiest, fastest
PAGE 3
Begin installation at corner with groove facing perpendicular wall if installing in a vertical orientation or with the groove facing the floor if installing in a horizontal orientation. This is usually the straightest and best reference for establishing a straight working line. Establish this line by measuring an equal distance from the wall at both ends and snapping a chalk line.