Instructions / Assembly

Page 3 of 3
Revised 11/27/17
Malibu Wide Plank Wall Installation
Instructions
Begin installation at corner with groove facing perpendicular wall if installing in a vertical orientation or with the groove
facing the floor if installing in a horizontal orientation. This is usually the straightest and best reference for establishing a
straight working line. Establish this line by measuring an equal distance from the wall at both ends and snapping a chalk
line. You may need to scribe cut the first row of planks to match the wall in order to make a straight working line if the wall
is out of square.
Use a flooring air stapler/nailer compatible with profile of material or a stapler/nailer of your choice. Test on a sample to
make sure that stapling/nailing will not cause dimpling (localized raised edges) in the finished plank. (Note: Be sure to
look at the face of the installed flooring at a low angle from a distance to see if dimpling is occurring as it is hard to see
when directly above the plank.) If dimpling does occur, STOP and adjust the stapler/nailer shoe and angle/place of staple
entry in order to avoid it. Malibu Wide Plank is not responsible for dimpling.
The warranty for installation of this product on walls or other non floor installations is for replacement of material only.
Malibu Wide Plank will not be responsible for any labor associated with replacing any product deemed having a
manufacturing defect before, during or after wall installation. Malibu Wide Plank will not be responsible for any damage
that occurs to the walls during plank replacement.
Call Customer Service Toll Free at 844-658-4700 with all Technical Questions Concerns