Owner's manual

CONNECTING T
HE
ACCEL 3-STAGE REV-LIMITER
TO AN
A
CCEL IGNITION SYSTEM
he ACCEL 3-Stage Rev-limiter uses special signals to communicate with your ignition
module, and your 3-Stage Rev-limiter can only be used with an A
CCEL ignition module.
or your rev-limiter to communicate with your ignition module
DIP-Switch-4, inside the
gnition module, must be re-set
UP.
• Open the ignition module’s cover plate (the one with the wires coming through it).
Unscrew the three screws and swivel it out of the way to reveal the
DIP-Switches.
• Using a small tool (A pencil is good) gently push
DIP-Switch-4 up.
Your A
CCEL ignition system’s internal
DIP-Switches are harder to access
than your rev-limiter’s buttons.
Set the ignition box’s rev-limit to the
highest value you ever expect to reach.
Your rev-limiter cannot override the
ignition’s designated rev-limit.
DIP-Switch-4
This A
CCEL 300+ ignition box has been
set to rev-limit an 8-cylinder
engine at 5,000 RPM.
The owner has
installed an A
CCEL
3-Stage Rev-limiter,
and has also set
DIP-Switch-4 up.
IMPORTANT POINTS TO REMEMBER
he rev-limit set inside your ACCEL ignition module is the engine’s ultimate rev-limit.
o outside control module will ever be able to override it. When setting
PEAK RPM on your
-Stage Rev-limiter it is a good idea to set it a little lower than the ignition module’s limit.
his allows you to program your A
CCEL 3-Stage Rev-limiter for its highest performance,
hile using the A
CCEL ignition module’s rev-limiter as a safety.
you remove your A
CCEL 3-Stage Rev-limiter. remember to re-set DIP-Switch-4 inside the
CCEL ignition module’s
• When connected to any control module, the ignition module’s DIP-Switch-4 must be UP.
• When not connected to a control module the ignition will not start with
DIP-Switch-4 UP
• When you have adjusted DIP-Switch-4, close the cover plate and
retighten all three screws.