Instruction Manual

ManualsBrandsMallory Ignition ManualsCarMallory MAGNETIC BREAKERLESS DISTRIBUTOR

3 www.malloryracing.com MALLORY IGNITION

FIGURE 1

WIRING DIAGRAM USING OEM PRIMARY (LOOM) RESISTANCE WIRE

NOTE: The purpose of resistance wire between the ignition

switch (12V) and the ignition coil positive terminal is to restrict

current flow through the ignition coil. Failure to use resistance

wire will eventually destroy the Ignition Module.

EXCEPTION: If your vehicle is equipped with a HYFIRE

Electronic

Ignition Control or similar aftermarket ignition control, use the

wiring procedures stated in the instructions included with the

ignition control.

To prevent false triggering and possi-

ble premature ignition failure, you

must use suppression type (carbon

core, spiral core, or radio suppression

core) spark plug wire.

Do not use solid core (copper core or

stainless steel core) spark plug wire

with any electronic ignition system.

ALL OTHER WIRES ORIGINALLY CONNECTED TO THE COIL (+) TERMINAL

LOOM RESISTANCE WIRE

12V/IGNITION

SWITCH

IGNITION MODULE

FEMALE CONNECTOR

ENGINE

GROUND

BROWN

GREEN

RED

DISTRIBUTOR WIRE HARNESS PART NO. 29349

FIGURE 2

WIRING DIAGRAM USING IGNITION BALLAST RESISTOR

NOTE: The purpose of an ignition ballast resistor between the

ignition switch (12V) and the ignition coil positive terminal is to

restrict current flow through the ignition coil. Failure to use an

ignition ballast resistor will eventually destroy the Ignition

Module.