Operating instructions

ManualsBrandsMalm Fireplaces ManualsHome building and DecorFire Drum 2

WARNING: Improper installation, adjustment, alteration, service or

maintenance can cause injury or property damage. Refer to this

manual. For assistance or additional information consult a qualified

installer; service agency or the gas supplier.

FOR YOUR

SAFETY

Do not store or

use gasoline or

other flammable

vapors and liq-

uids in the vicin-

ity of this or any

other appliance.

Malm Fireplaces, Inc.Malm Fireplaces, Inc.

Malm Fireplaces, Inc.

368 Yolanda Avenue

Santa Rosa, Ca 95404

(707) 523-7755 - Fax: (707) 571-8036

Assembly And Installation Instructions

LEAVE THESE INSTRUCTIONS WITH THE OWNER.

Listed Vented Gas Fireplace

FOR YOUR SAFETY

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use

any phone in your building.

Immediately call your gas supplier from a neigh-

bor's phone. Follow the gas supplier's instruc-

tions.

If you cannot reach your gas supplier; call the

fire department.

Fire Drum GF-2/GF-3

ANSI Z21.50-1996

Summary of content (12 pages)

PAGE 1
Malm Fireplaces, Inc. 368 Yolanda Avenue Santa Rosa, Ca 95404 (707) 523-7755 - Fax: (707) 571-8036 Fire Drum GF-2/GF-3 ANSI Z21.50-1996 Assembly And Installation Instructions LEAVE THESE INSTRUCTIONS WITH THE OWNER. Listed Vented Gas Fireplace FOR YOUR SAFETY FOR YOUR SAFETY WHAT TO DO IF YOU SMELL GAS Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Do not try to light any appliance.
PAGE 2
GENERAL INFORMATION This appliance has been tested in accordance with National Safety Standards and for installation and operation as described in this manual. Please read all the instructions before beginning your installation. Check with your local building code agency to ensure compliance with local codes. In the absence of local codes the installation must comply with National Fuel Gas Code ANSI Z223.1- current edition. Installation and repair should be done by a qualified service person.
PAGE 3
VENTING The unit is a vented gas fireplace and must be connected to a chimney/flue in accordance with the code, using the chimney manufacturer's instructions. This appliance must not be connected to a chimney flue servicing a separate solid fuel burning appliance. VENT DAMPER This appliance is equipped with a factory installed vent damper device, located in the first section (starter section) of pipe which attaches to the collar of the appliance.
PAGE 4
CLEARANCES Make sure that minimum clearances to combustible materials are maintained during installation including adequate space for the proper operation and servicing of the heater. The minimum clearances from the appliance to combustibles are shown on figures 1 and 2. Place the appliance on a flat, solid, continuous serface (i.e. wood, tile, concrete, metal). NOTE: Ensure that the combustion air opening of the heater is not obstructed.
PAGE 5
Installation Instructions Do Not Install In A Mobile Home READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION. 1. Position unit to comply with the minimum clearances to combustible materials. Minimum clearances are shown in figures 1 and 2. It is recommended that no overhead cross members in the ceiling or roof be cut. Reposition unit if necessary, being careful not to move closer than the minimum clearances. VENTING REQUIREMENTS Use a masonry, "B" vent or class "A" chimney.
PAGE 6
Installation Instructions continued 4. Lift the control cover. Using a 1/2" x 8" nipple, extend the gas supply line to the front of the unit. 5. Attach gas supply shut-off valve part # GF-1A to the supply line. 6. Connect 3/8" x 12" flex connector part # GF-1B to the shut-off valve. 7. Make certain the gas valve is closed. Turn on gas supply and test for leaks using a soapy water solution. 1. ASSEMBLE UNIT. GF2 A. Place the body section into the base. Align the opening with the control cover. B.
PAGE 7
Installation Instructions continued Ceiling Support Box 2. Attach the slip connector pipe to the support box. Insert the slip connector pipe into the support box and twist to lock into place. 3. Slip the middle section over the slip section only far enough to allow installation of the starter section. While holding the middle section place the starter section with the thermal damper at the bottom, into the hood.
PAGE 8
Installation Instructions continued GAS LOG SETUP 1. Place the legs of the grate into the leg holders. 2. Spread the vermiculite first, no more than 1/4" thick, over the burner area. Spread glowing embers evenly over the vermiculite. After lighting the unit spread the embers to acheive an even coal effect. 3. Place fire logs as shown, using alignment knobs on the logs. 4. Light the pilot following lighting instructions. Turn the valve to on and the burner should light.
PAGE 9
OPERATING INSTRUCTIONS A. Follow these instructions exactly. This appliance has a pilot which must be lighted by hand. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the the floor. WHAT TO DO IF YOU SMELL GAS Do not try to light any appliance. Do not touch any electric switch; do not use any phone in your building. Immediately call your gas supplier from a neighbor's phone.
PAGE 10
MAINTENANCE INSTRUCTIONS GENERAL SAFETY 1. Always shut off the gas supply and make sure that the heater is cool before starting any servicing operation. 2. Always check for leaks after servicing. 3. Always check for correct combustion and ventilation air flow. The flow of combustion and ventilation air must not be obstructed. 4. Always check that the appliance area is clear and free from combustible materials, gasoline, and other flamable vapors and liquids. PERIODIC CHECKS 1.
PAGE 11
ITEM PART NO. 1-A 1-B 1-C 2 3 4 5 6 7 8-A 8-B 8-C 9 9 10 11 12 13 14 15 16 17 DESCRIPTION GF-1A-B3812-VIM GF-1B GF-1C GF-2-RV20 GF-3 GF-4-J-100A GF-5 GF-6 GF-7-219-3/8 GF-8A GF-8B GF-8C GF-9-42 GF-9-53 GF-10 GF-11 GF-12 GF-13-Mark21 GF-14 GF-15-MBT GF-16 GF-17 Gas Shut Off Valve 3/8" x 12" Flex Connector 3/8" Fitting - Brass Pressure Rgulator Gas Valve Mounting Bracket Gas Control Valve 3/8" x 1 1/2" Black Nipple 3/8" - 90 Degree Elbow - Black 1/8" M.I.P.
PAGE 12
1 Rear Log 2 Front Bottom Log Adjustable Air Shutter Figure F 12 3/4" 12 3/4" Support Box Pilot Flame Frame In 13" x 13" Top Slip Pipe Top Slip Pipe Middle Pipe Middle Pipe Damper Pipe Damper Pipe Damper Damper Piezo Lighter Gas Control Valve Flex Connector Gas Supply Line Flex Connector Gas Supply Line GF-2 Piezo Lighter Gas Control Valve GF-3 Malm Fireplaces, Inc. 368 Yolanda Avenue Santa Rosa, Ca 95404 (707) 523-7755 - (800) 535-8955 Fax: (707) 571-8036 email: info@malmfireplaces.