User Manual

M
M
A
A
L
L
O
O
N
N
E
E
R
K-Rack is sold in singles (MPG353) and sets of two (MPG354). Please review instructions before installation.
Molded Frame
Suction Cup
Allen Wrench
Allen Head Bolt
Washer
Lock nut
Components
Assembly
Required
To assemble your K-Rack:
1. Remove all components from the box.
2. Mount Suction Cups to the Molded Frame.
3. Insert Allen Head Bolts into Cups and through Frame.
4. Place Washers on exposed ends of Bolts.
5. Install Lock nuts to the Bolts with Allen Wrench.
Loading and Usage Precautions:
Gently place the bow of the kayak into the lower K-Rack. Continue to hold the kayak to prevent slippage.
Walk back to the stern of the kayak. Lift the kayak and walk it forward sliding across the K-Rack(s).
Tie-down the kayak and then remove the K-Rack(s) before driving away.
To unload the kayak, simply install your K-Rack(s) and reverse the above process.
The K-Rack is a loading device only and should never be used for transport or storage.
MALONE AUTO RACKS, 81 County Road, Westbrook, Maine 04092
Phone: [phone] Fax: [phone]
Website: www.maloneautoracks.com Email: [e-mail]
Install K-Rack on a Hatchback or SUV:
1. Conrm the mounting surface
area and the suction cups are
clean and free of dust.
2. Secure a K-Rack to the rear
window as shown. For MPG353,
go to instruction # 4.
3. Secure the 2nd K-Rack (MPG354)
to the roof of the vehicle.
4. Ensure the suction cup(s) are
well attached before loading.
Install K-Rack on a Sedan:
1. Conrm the mounting surface
area and the suction cups are
clean and free of dust.
2. Secure a K-Rack to the trunk
as shown. For MPG353,
go to instruction # 4.
3. Secure the 2nd K-Rack (MPG354)
to the rear window of the vehicle.
4. Ensure the suction cup(s) are
well attached before loading.
NOTE: DO NOT OVERTIGHTEN LOCK NUTS.
AFTER INSTALLATION, THE SUCTION CUPS SHOULD
PIVOT UP AND DOWN FOR CONTOURED SURFACES.