Instruction Manual

SECTION 3 - Manual Control
3.1.1
© Copyright 2008DN IS-IPPC101.1
® Registered trademark MAMAC SYSTEMS, Inc.
18 of 20
Manual Control: Any output can be controlled manually from the web browser by clicking on the
Manual Control icon on the navigation bar. A new page will be served up showing the current
output control status and state. Suppose the user desires to turn output #1 on manually. Click the
Manual radio button for Output #1 and click Save. The status will change from Automatic to
Manual. Now click the On radio button for Output #1 and hit Save. The Output #1 state will
change from Off to On. Now navigate to the Main page and the output will be On and the Manual
Control Status will show output #1 in manual state.
To turn the output back to automatic, click Manual Control on the navigation bar, change the
state to Off and click Save. Again click the Automatic radio button and hit Save. Output is back
under automatic control. CAUTION: In case of power failure, all outputs under manual
control will revert back to automatic control when power is restored.
Save
13.34:59
May 9, 2008
IP Sensor Appliance:
Main
Manual Control
Data Logging
Configuration
MAMAC UNO
Configuration | Password/Clock
Copyright 2008
c
www.mamacsys.com
R
Registered trademark MAMAC Systems, Inc.
MANUAL CONTROL
Current Status
Output Status
Directions:
1. Auto
Auto
Auto
Auto Manual
Manual
Manual
Manual Automatic
Manual
Automatic
Automatic Off
Off
Off
Off On
On
On
On Off
Off
Off
On2.
3.
4.
1. Change the ‘Output Status’ to ‘Manual’, click ‘Save’..
Set the ‘Control’ to the desired setting (On or Off), click ‘Save’.
The ‘Current Status’ will switch to desired state.
Follow steps 1 and 2 to change back to ‘Automatic’.
2.
3.
4.