Owner's manual

SECTION 3 - Network Configuration Options

3.0.0

® Registered trademark MAMAC SYSTEMS, Inc.

13 of 17

DN IS-IPSM101.1

Router

Ethernet Hub

Router

Bridge

Router

Wireless Router

Configuration 1

Configuration 2

Configuration 3

Cat 5 Patchcord Cable

Static IP Address: After the initial configuration, power down the appliance by unplugging the

power terminal block and disconnect the crossover cable. CAUTION: Each time the static IP

is changed, power cycle the appliance to load up the new static IP. Connect the

Maverick to the ethernet as shown in Figure 6. Three options are available -- 1) Use a CAT 5

patchcord and plug it into a hub or switch and connect the hub/switch to a router on the web. 2)

Use a CAT 5 cable to connect directly to the router. 3) Configure an Ethernet Bridge and router

and connect the appliance to the Bridge with a CAT 5 cable. For more information on wireless

802.11 B/G configuration, please refer to AN IP802.11.

Connect the pulse input as shown in Figure 3 (Section 1.4.2). Power up the appliance. To connect

to the appliance, launch a web browser (Internet Explorer or Firefox) on a laptop/PC, PDA or

web-enabled mobile/cell phone. Delete all text in the browser address bar and punch in the static IP

address and hit enter. The Maverick will connect and the Main page will launch. Have fun!

Figure 6

Sub Metering

Appliance

Sub Metering

Appliance

Sub Metering

Appliance