Owner's manual

SECTION 3 - Network Configuration Options

3.0.1

® Registered trademark MAMAC SYSTEMS, Inc.

14 of 17

DN IS-IPSM101.1

DHCP IP Assignment: If during initial configuration DHCP was enabled, power down the

appliance and disconnect the crossover cable. Connect the Maverick to the ethernet as shown in

Figure 6. Three options are available -- 1) Use a CAT 5 patchcord and plug it into a hub or switch

and connect the hub/switch to a router on the web. 2) Use a CAT 5 cable to connect directly to

the router. 3) Configure an Ethernet Bridge and router and connect the appliance to the Bridge

with a CAT 5 cable. For more information on wireless 802.11 B/G configuration, please refer to

AN IP802.11.

Connect the pulse input as shown in Figure 3 (Section 1.4.2). Power up the appliance. As soon as

the Maverick comes on line, it will search for a DHCP server and lease a new IP assignment. As

soon as it gets a new DHCP IP, it will send an email to one or both email addresses with the new

DHCP IP. Once you receive the email, connect a laptop/PC, PDA or web-enabled mobile/cell

phone to the same network and launch the web browser. Enter the appliance internal IP address

and connect. Each time the DHCP server assigns a new IP to the appliance, an email will be

generated to keep the user abreast of the latest DHCP-assigned internal IP of the Maverick.