User Manual

9.6 Mirror Up Delay

To change from the Self-timer to the Mirror Up setting, press the

shutter button so the mirror goes into the upright position. Once the set

time has expired, the shutter releases, and the mirror returns to the lower

position. Separately purchased electronic cable release RE401 can be

used to eliminate camera shake.

When using autofocus, the operational method is the same as steps 1 to

3 when using M.UP and autofocus.

1-3 (reference steps 1-3 in the Mirror Up Autofocus method).

4. Press the Self-timer button and turn the front dial to ON.

5. Turn the rear dial to select the time needed. 0.5 seconds to 10

seconds allows for increases by the second, 10 to 90 seconds

increases by 10 seconds per turn. For 2 to 10 minutes the value

increases by the minute and 10 to 60 minutes increases by 10

minutes per turn.

6. Frame the subject through the viewﬁnder and half press the shutter

button to ensure the focus and framing is correct.

7. Press the shutter button and the mirror goes to the upper position,

then after the exposure the shutter releases and the mirror returns to

the lower position.

Electronic Shutter Release Contact

For Mirror Up, long exposure, or slow shutter shooting, use the

electromagnetic cable release RE401 or the remote control RS402.

Please remove the camera’s terminal cover and insert the remote plug

carefully until it ‘clicks’ into position.

Eyepiece Shutter

Close the eyepiece shutter when there is a strong light source behind the

camera.