Specifications

Loading Film in the Magazine
When the pressure plate (120/220) is set erroneously:
1. Open the back cover of the
magazine.
Hold down the button and press the
button to the right.
2. Take out the roll-film insert.
Squeeze the center block “645” between
your fingers and pull it out.
When you load film for the first time, remove
and discard the protective paper cover which
is attached to the film rails in the magazine.
3. Set the film type (120 or 220).
Push and hold the pressure shaft located
under the 645 center block. This frees the
pressure plate and permits it to be turned and
set for either 120 or 220 film.
4. Attach an empty spool to the roll-
film insert.
Flip the roll-film insert's lower spool clip
“SPL” away from the spool, fit an empty spool
between take-up spool studs , and return the
spool clip “SPL” to the original position.
5. Set the film.
Flip the roll-film insert's upper spool clip “FILM”
away from the spool, fit a roll of film as shown in
the illustration, and return the spool clip
“FILM” to the original position.
Film path
Be sure to align the lock pins with the holes on the pressure plate. The film type
should be displayed on the LCD of the magazine when the film insert is loaded.
A roll of film can be inserted into the magazine whether the magazine is installed onto
the camera body or not.
31 32
Result
220 type
120 type
120
220
- Inaccurate focusing.
- Film winding after 16 exposures.
- Inaccurate focusing.
- After the 16th exposure has been made, the shutter can be released a
few times until the film's leader paper has run out, but the shutter
blades may be damaged by the leader paper at the film end or by the
film's sticker.
Insert the dark slide in the magazine and press the shutter button and
the mid-roll film advance button simultaneously. (See page 40)
Plate
Setting
Loaded
Film