Specifications

69 70
SET
M.UP
AEL
P
Av
Tv
M
X
CF
SET
M.UP
AEL
P
Av
Tv
M
X
CF
Exposure compensation in typical multiple exposures
The optimum exposure compensation value will vary depending on actual photo-
graphic conditions. We recommend taking test shots.
To cancel the Multiple Exposure Mode
When the camera is in the multiple exposure mode, it shows the multiple exposure
mark “ ” on the main LCD panel.
To check number of the remaining shots, press the multiple exposure setting button.
To increase number of exposures to more than six in the middle of multiple expo-
sures, or to decrease the number of exposures, press the multiple exposure setting
button and turn the front or rear dial.
When number of the exposures is terminated in the “C” (continuous) shutter release
mode, the top LCD panel shows “End”, and the camera automatically cancels the
multiple exposure mode.
To cancel the multiple exposure mode before taking the first shot, press the multiple
exposure setting button and change the displayed number to 0.
Make sure to pull the dark slide out. And hold
the emergency film winding button and half-
press the shutter release button.
The camera advances the film by one frame
and then exits from the multiple exposure
mode.
If the film holder is detached in the middle of multiple exposure, “-no- ” will blink on
the top LCD and go out in 3 seconds. The multiple exposure mode is now cancelled.
However, as the the film holder is still in the multiple exposure mode, the camera will
resume the multiple exposure mode when the same film holder is attached. The mul-
tiple exposure mark “ ” will blink on the LCD, and number of the remaining expo-
sure will be automatically set at “1”.
Guideline for exposure compensation during Multiple Exposure
Mode
As in the multiple exposure mode, several shots are exposed on a single frame,
exposure compensation may be needed depending on the subjects and the back-
grounds.
Using the multiple exposure mode, you can expose several shots on the same frame.
Multiple Exposure Mode
1. Turn the shutter release mode selector to the
“S” or “C” position.
2. Keep pressing the multiple exposure setting
button for approximately one second to enter
the multiple exposure mode.
You will see the multiple exposure mark “ ”
and number of exposures (0 is default) on the
top LCD panel.
3. Turn the front or rear dial to set the number
of desired exposures.
By turning the front or rear dial, you can specify
2 to 6 multiple exposures. After 5 seconds with
no operation or if you press any of the other
buttons, the setting will be stored.
4. Press the shutter release button.
The camera will make multiple exposures on
the same frame.
After exposures of the specified number have
been made, the camera will automatically
cancel the multiple exposure mode.
Multiple exposure can be made each time the shutter is released without
setting number of the exposures in advance.
Custom settings (C-33 on page 94)
Exposure compensation
−1.0
−1.5
−2.0
Number of exposures
2
3
4