Instruction Manual

Before Loading the Film
[Setting the film speed]
Set the film speed of the film being used
by lifting up the outer rim of the shutter
speed dial and rotate it until the correct
ISO value appears in the window.
[Opening/closing the back cover]
While depressing the back cover lock
button, simultaneously push down the lock
lever in the direction of the arrow and the
back will open.
When closing the back cover, securely
press both corners until it clicks.
[Setting the film type]
This camera can use either 120 or 220/
135 film. To set for the type of film used,
simply rotate the pressure plate in either
direction of the arrow until the white dot is
at "120" or "220/135".
When set, "120" or "220/135" will appear
in the small window under the memo clip
on the rear of the camera.
The number of exposures on the film
counter is automatically set at 10 for 120
film and 20 for 220 film, according to the
position of the pressure plate.
• Be sure to set the exact film speed, as
otherwise incorrect exposure will result.
• If pressure plate position is not matched
to the type of film used, a picture can be
taken but it might be out of focus.
12