User manual

INSTALLAT ION

mini HE --- Installation & Servicing

16 CUTTING THE FLUE

Notes.

A If using the extension ducts go to Frame 17.

B If stand ---off frame is used it is essential this is taken into

consideration when marking the flue (see Frame 11).

1 Measure and note the wall thickness.

2 For side flues measure and note the gap between the

casing and wall.

3 From the table in Frame 11, determine the flue length

required. Mark and cut both outer and inner tube.

Ensure the support spring clip is in position to facilitate

cutting.

4 Toensurethetubeiscutsquare,markthefluealltheway

around.

Measure from

this

RING

17 FITTING THE EXTENSION KITS

1 Fittheinnerflueextensionductontotheinnerflueduct.

2 Fit the out er flue extension duct onto the outer air duct.

3 Repeat steps 1 and 2 if a second flue extension is

required.

4 Measure and mark the flue length required onto the flue,

measuring from the ring near the terminal. (Refer to Frame

11 for the detail of flue length calculation).

5 To ensure a square cut, mark the flue all the way around.

6 D e --- b u r r t h e c u t e d g e s .

Measure from

this

RING

INSTALLATION