Specifications

0 Loading and Advancing the Roll Film
l Loading the film
L
1. Open the back cover by pulling out the
back cover latch, while slightly pressing the
back cover. Remove the film
insert from
the holder.
x; When loading and unloading film, avoid
direct sunlight. Choose a location in the
shade.
+ Regardless of whether the roll film holder
is attached to or detached from the camera
body,
loading and unloading the roll film
can be conducted in the same manner
h Use 120 roll film with the 120 roll film
holder, and 220 roll film with the 220 roll
film holder.
2. While pressing the left side spool release
pin
(43), insert a new roll of film on the film
spool stud.
Load the film so that the leader paper can
be pulled out along the arrow of the leader
paper guide mark (36)
In this way, the black
side of the leader paper will appear on the
outside.
+ If the black side does not appear on the
outside, reload the film, reversing the film
position.
3. Pull out the leader paper and insert the
tip into the groove of the take-up spool.
h Position the film so that the leader paper
winds evenly between the spool flanges;
otherwise the film may be taken up unevenly,
causing trouble.
18