Specifications

0 Lens Hood
0 Carrying Strap
l Attaching
This lens hood can be used commonly for the 90mm,
127mm. 180mm. and 250mm lenses.
1. Screw the attachment ring into the front of the Ions
mount.
2.
Pull the folded rubber hood
straight out. using it as the
hood for the 127mm. 180mm. and 250mm lenses.
3.
For the 90mm lens, fold the hood back halfway
To fold the hood, pull it straight out, place the hood on a
flat surface, and push down from the top to easily fold the
lens hood
You can also leave the hood
on the lens for
portability by
pushing back and turning out the hood while it is attached
to the lens.
A filter can be screwed
in between the lens and the hood,
or in front of the lens hood.
While holding both sides of the
strap attaching metal, slide the
attaching metal toward the
hanging direction, after fitting
and pressing the round hole on
the metal back side to the lug
for strap on the camera body.
Note:
Always attach and use the strap
so that it and the strap attaching
metal are straight.
When changing the strap hang-
ing direction, always reattach
the strap.
* If the strap attaching metal is
connected to the accessory
shoe side in reverse, detaching
will be difficult.
30