Operation Manual

Mando Footloose user manual
20
English
A new way of moving
21
For the proper use of the product
How to use the
product properly
G
Securing a clear view
Cautions in rainy weather:
in rainy weather, it is hard for a tire to grip the road. Also, it is hard to secure the safety of the rider
and other car drivers due to low braking power and unclear visibility. Wet roads increase the risk of
accidents. Ensure the product is only used at low speeds and learn how to stop safely on a wet road,
by braking gently.
Suggestions for a night ride:
riding Mando Footloose at night is more dangerous than riding it during day time. Try to avoid riding at
night or in early mornings since a rider cannot be seen by other car drivers or pedestrians. For a ride at
night or in early mornings, use lights and wear safety accessories.
Use a light during a night ride.
Check regularly if the rear reflector is well attached to the product.
Do not remove the rear reflector. It is necessary for safety. Without the rear reflector, an accident may
be caused because a rider cannot be seen by car drivers or pedestrians. If you collide with a car, you
may be critically injured and even die. For a night ride, keep the following suggestions in mind:
- Wear a helmet that has reflective stripes on it. Attach a safety light to your body and Mando Footloose.
- Install a brightly colored light so you can easily be seen by car drivers or pedestrians.
- Ensure that the light and reflector is not blocked by any object.
- Ensure that the rear reflecting plate is installed properly.
- Ride at a slow speed for your safety.
- Avoid riding in a dark area or crowded place.
- Avoid riding off road or on uneven roads.
- Ride on familiar routes and protect yourself with defensive riding.
Replacement of parts, installation of accessories:
There are many kinds of parts and accessories that can improve the riding quality, performance and
design. However, you should be cautious when you replace parts or install accessories.
The safety is not ensured when parts are replaced and accessories are installed to Mando Footloose
because the manufacturer of Mando Footloose has not tested the compatibility between
Mando Footloose and these parts / accessories. Before installing any part, accessory or tire on
Mando Footloose, contact the store to check the compatibility. Read the manual of the part / accessory
to check the compatibility between Mando Footloose and the part / accessory.
If the parts / accessories are not compatible with Mando Footloose, do not install them. In appropriate
use of parts / accessories may cause a critical injury .
For replacement of parts, for safety and warranty service it is recommended to use the genuine parts.
Contact the store before replacing any parts / accessories.
It is important to tighten the nuts and bolts according to the accurate torque values. Always tighten
the nuts and bolts to the specified torque values. If a bolt is tightened too tight, it may be over-
stretched or deformed. Loosely screwed bolts may cause wobbling and fatigue during a ride. Thus,
tightening the bolts too tight or loose may damage the bolts. Make sure to use the accurately adjusted
torque wrench to tighten the bolts and nuts. If you don’t have a torque wrench, please contact the
store or the specialist.
Part Appropriate Torque Values
Handlebar clamp 8Nm
Handle grip 3Nm
Handle post 6Nm
Seat 6Nm
How to place a light
2) Open the cover of the light by pushing
the cover backward.
1) Check if all components are in the
package; a light, light holder, nut, and
batteries.
3) After placing batteries, close the cover.
4) Place the light holder on the desired
location of the handlebar.
7) Installation completed (Press the power
button for 2~3 seconds to turn the
power on and off).
6) Place the light on the light holder.
5) Put the tip of the band to the light
holder, and assemble the band and nut.
H
Accessories