Operation Manual

Mando Footloose user manual

English

A new way of moving

1) Unscrew the bolt in the band part (use a

Phillips screwdriver).

3) Fasten the bolt after adjusting the

degree of ﬁxation and angle (The angle

of the reﬂecting light should be perpen-

dicular to the ground).

2) Place the band part on the seatpost.

4) Installation completed.

2) Place the bell on the handlebar by pull-

ing the band part of the bell.

4) Installation completed.

3) Fasten the bolt with the nut by screwing

it clockwise.

1) Check if all components are in the pack-

age; a bell, Phillips bolt and a nut.

How to place a bell

How to place a rear reﬂecting plate

Be cautious, the nut easily falls off during installation.

How to use the stand

1) Place the pedal parallel with the ground. 2) Pull a rod with hand.

4) Move the rod until it is placed as shown

in the picture

3) Move the rod while pulling it.

5) Fix the rod to the ‘stop’ position of the

stand holder.

6) Repeat the same steps for the other rod.

7) Place the unfolded stand on the ground

so the rods stretch to the ground (When

folding the stand, follow the steps in

reverse order).

The maximum load capacity of the stand is 25 kg. If you ride on Mando Footloose or put

too much force on the product while it is on the stand, the stand may be damaged.

Accessories Accessories