Operation Manual

Mando Footloose user manual
04
English
A new way of moving
05
1. Tire pressure
45~55psi (MAX 70psi) / Use a proper pump when pumping air into the tires.
(The number is based on the original tire installed to the product. Air pressure
may vary with the type of tire)
- Excessive air pressure -> Uncomfortable riding quality
- Insufficient air pressure -> May cause a flat tire or inflexible handling.
2. Battery energy check
- The remaining amount of energy in the battery can be checked on the HMI
screen.
(For more information about charging the battery, please refer to ‘F. Battery
and Charging’)
3. Brakes
- Check that front and rear brakes work properly.
(Front brake -> left lever, rear brake -> right lever)
It works the opposite way in the U.K., Singapore and several
other countries.
- Practice braking by gripping the brake levers gently.
(Abrupt use of the brakes may cause injuries)
4. Seat height and handle height / adjustment and locking
- Incorrect seat height and handle height may cause uncomfortable riding and
handling and reduce a rider’s coordination of the bike which may potentially
cause injuries.
(For more information about adjusting seat height and handle height, please
refer to ‘C. Adjustment of the Product’)
- When the handlepost clamp / handlepost folding lever is not fixed tightly the
steering might be affected.
(The rider may lose balance and get injured)
5. Changing operating modes
- Practice changing the operating modes before riding. (For more information
about HMI setting including switching operating modes, please refer to ‘E.
Riding Instructions’)
6. Other safety checklist
- During night riding, ensure that the front / rear reflectors are fixed, clean and
working properly for identification and safety. Additional lighting is essential
in most countries by law.
- Ensure that your shoe strings are tied. (Untied shoe strings may be caught
up by a pedal or crankshaft)
- Ensure that each part of the bike is fastened properly for operation.
(Check the tightness and operation of all parts including the brake cable and pedals)
Loosely fixed screws or bolts may cause injury and excessively tight screws
or bolts may affect operation and cause damage to the product.
- Ensure that the front / rear wheels are correctly aligned.
-> Bounce the front / rear wheels by lifting it up 2~3 inches off the ground.
-> Rock the front / rear wheels side to side. If any movements or wobbles
are detected, do not operate the product.
B
Items to be checked
before riding
Before every ride, it is important to carry out a safety check to avoid any
problems.
Manipulating the brake lever
HMI-battery
Handlepost folding lever
HMI-Operating mode
If any defect listed in the checklist is
found, please contact the store.
Mando Footloose body
HMI (Information display) Bell Light Rear reflector
General battery charger
High speed battery charger
(sold separately)
Introduction
Checking the components
Before riding, check the components included in the box.
* The components of this product may be changed, without prior notice, to improve the function of the product.
A-2
User manual Stand
18
17
15
16