WIRELESS REMOTE CONTROL USER MANUAL TR300 Transmitter RC270D Indoor Dimmer Receiver for Lighting Introduction The TR300 Transmitter is designed especially to control all our Indoor Dimmer Receiver RC270D. With its dual mode (on/off and dimmer functions), you can use this Transmitter to control the Receivers for switching on or off, dim or bright the plugged-in lamp. The Transmitter has 4 channels, which can control up to 4 receivers.
BUTTON CONFIGURATION DUENNA OE A LDA een Transmitter TR-5028 ON The 4 ON button will turn on the receiver of the respective channel OFF The 4 ON button will turn on the receiver of the respective channel BRIGHT Increase the brightness of the plugged-in lamps (only applicable for Dimmer Receivers RC270D) DIM Decrease the brightness of the plugged-in lamps (only applicable for Dimmer Receivers RC270D) RESET (located inside the battery compartment) Generate a new System code Dimmer Receiver RC270D LEARN Learn
Repeat the above procedures if you have more than 1 Receiver, The Receivers can be set to same channel or different channels. depending on whether you want to control the Receivers together or separately. The system code and channel number of the Receivers will be retained if they are unplugged from the power outlet for less than 10 minutes. If the Receivers have been unplugged for too long duration, the above learn’ procedures needs to be performed again.
Technical Specifications RC270D Dimmer Receiver Ratings: 120V 60Hz Transmission Range: 25 meters in open area Maximum Load: 300W incandescent lamp or Halogen lamp (120V) Transmitter Power Source: 9V Battery System Code: 4.096 combinations This device complies with Part 15 of the FCC Rules Operation is subjected to the following two conditions: 1. this device may not cause harmful interference, and 72. this device must accept any inference revived, including Interference that may cause desired operation.