User's Manual

The back cover should be mounted vertically with the terminals on the top

Thread the existing wiring through the big center hole from the back and set the back cover

vertically on the wall

Select two appropriate mounting holes and mark the locations with a pencil (If necessary, use a

level to make sure the thermostat is positioned straight)

Remove the back cover from the wall and drill two 3/16 inch holes in the marked screw positions

Insert the wall anchors into the holes completely (If necessary, use a hammer to tap-in lightly)

Mount the back cover to the wall using the two screws (Make sure the metal terminals are on the top)

Attach the thermostat body to the back cover (that is already mounted on the wall)

by carefully aligning the two pieces and pressing firmly until they snap together

Mounting the back cover of the thermostat

First attach to backplate to the wall,

then press the faceplate into place