User's Manual

ManualsBrandsMandolyn Electronic Technology ManualsElectronicsWeather Station Receiver

WIRELESS THERMOSTATION

INSTRUCTIONS FOR USE

View from the back of the base unit

SAFETY INSTRUCTIONS

Warning

Batteries are extremely dangerous when swallowed.

Therefore keep batteries and devices out of the reach of small children. If a battery has been

swallowed seek immediate medical advice. The cells supplied must not be recharged, reactivated

by any other means, is-mantled, exposed to an open flame, or short-circuited.

-Although the thermometer sender is weather-proof, please be sure that it is not placed where it

will be exposed to rainfall and direct sunlight.

-Do not use abrasive or caustic cleaning agents to clean the base station or sensors. Doing this may

damage the surface or lead to corrosion of electronic parts.

-Furniture today is often coated with a wide range of varnishes and plastics and is treated with

various substances. Therefore, it cannot be fully ruled out that some of these substances contain

components that can damage or soften the rubber feet. If necessary, put the base station on

something that will not slip.

- If a sensor is exposed to very low temperatures for an extended period of time, the batteries may

lose power, which may cause the transmission range to be limited. Higher temperatures also reduce

battery performance.

Wall-mounting notch

°C/°F button

Reset button

Battery

compartment

Summary of content (7 pages)

PAGE 1
WIRELESS THERMOSTATION INSTRUCTIONS FOR USE View from the back of the base unit Wall-mounting notch °C/°F button Reset button Battery compartment SAFETY INSTRUCTIONS Warning Batteries are extremely dangerous when swallowed. Therefore keep batteries and devices out of the reach of small children. If a battery has been swallowed seek immediate medical advice. The cells supplied must not be recharged, reactivated by any other means, is-mantled, exposed to an open flame, or short-circuited.
PAGE 2
USING THE THERMOMETER FOR THE FIRST TIME ! Set up the sensor for use first so that the base station can receive a signal immediately. Using the sensor for the first time 1.Remove the sensor from its holder by gently lifting the holder up and carefully pushing it back. 2.Unscrew the battery compartment screw and lift off the cover. 3.Insert two of the batteries included with purchase. Ensure correct polarity +/-as shown in the compartment. 4.Replace the cover and tighten the screw.
PAGE 3
Clock Setting • Hold “Snooze/Mode” key to go into Clock Setting Mode; • Press “Hour” key to increment hour digit and “Min” key to increment min digit; Press “Remote/AM/PM” key to clear second digit • Press “Year/Alarm” key at clock display mode, the second digit will toggle between second display and weekday language display; • Press “Remote/AM/PM” key to clear second digit if showing second digit; or, to change the language display by pressing “Remote/PM/AM” key.
PAGE 4
MINIMUM AND MAXIMUM TEMPERATURES The base station saves measured minimum and maximum temperatures from each sensor and also the room temperature reading since initial use or since the temperature was last erased. Call-up data Press the HOUR/MAX button once to display the saved maximum temperatures of the currently displayed sensor at the base station. MAX is displayed to the left of the temperature. To display the saved minimum temperature, press the MINUTE/MIN button.
PAGE 5
time is reached. -Pressing the SNOOZE/MODE button will program the alarm to go off about 5 minute later. -If no button is pressed to shut the alarm off, the alarm will continue to sound for about two minutes. Turn off the alarm feature 1.To turn off Alarm setting, press the SNOOZE/MODE button twice from Clock mode until the symbol for Alarm is shown at the bottom of the display. 2.Press the YEAR/ALARM button. The ON displayed next to Alarm goes out.
PAGE 6
After changing the batteries in a sensor, you must register sensor at the base station again as described in chapter “Manually registering a senor ”. CARE AND MAINTENANCE Protect the base station and sensor from dust, impacts, extreme temperatures and direct sunlight. If needed, wipe it with a dry cloth. Do not expose the base station to any moisture. The sensor is protected against humidity. If you want to mount it outdoors, look for a protected place that is not directly exposed to sunlight or rain.
PAGE 7
Time display format: Weekday display: 24 hr 5 languages (German, English, French, Italian, Spanish) We reserve the right to make technical and design changes when improving the product. FCC Statement The statement required by 15.105 is as follows: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.