User's Manual

USING THE THERMOMETER FOR THE FIRST TIME
! Set up the sensor for use first so that the base station can receive a signal immediately.
Using the sensor for the first time
1.Remove the sensor from its holder by gently lifting the holder up and carefully pushing it back.
2.Unscrew the battery compartment screw and lift off the cover.
3.Insert two of the batteries included with purchase. Ensure correct polarity +/-as shown in the
compartment.
4.Replace the cover and tighten the screw.
Using the base station for the first time
1.Open the battery compartment on the rear of the base station.
2.Insert two of the batteries included with purchase. Ensure correct polarity +/-as shown in the
compartment.
3.Close the battery cover.
After inserting the batteries, the current room temperature is displayed.
The base station now tries to pick up signals from sensors for 3 minutes.
If no signal is detected, bars are shown on the display.
As soon as the base station has detected a sensor signal, one beep tone is emitted. The base station
display then shows the temperature value received from the sensor.
If reception is lost before the time can be set, then place the base station, which has better
reception, such as, near a window. Press the R button on the rear of the base station. This will
restart the search for signals from sensors.
BASIC THERMOMETER SETTINGS
You can make the following settings on your thermometer:
~ Display temperature in Celsius (°C) or Fahrenheit (°F)
~ Setting the time
~ Date
~ Language for displaying day of the week:
D=German
E=English
F=French
I=Italian
S= Spanish
Selecting Centigrade or Fahrenheit scales
To have the temperature displayed in Centigrade or Fahrenheit, press the °C/°F button on the rear
of the base station.