User's Manual

Clock Setting
• Hold “Snooze/Mode” key to go into Clock Setting Mode;
• Press “Hour” key to increment hour digit and “Min” key to increment min digit; Press
“Remote/AM/PM” key to clear second digit
• Press “Year/Alarm” key at clock display mode, the second digit will toggle between
second display and weekday language display;
• Press “Remote/AM/PM” key to clear second digit if showing second digit; or, to
change the language display by pressing “Remote/PM/AM” key. The sequence is E –
D – F – I – S (English, German, French, Italy, Spanish )
• Press “Snooze/Mode” key to cease the setting and back to clock display
• Press “Remote/AM/PM” at clock display mode to change between 12/24 hr display
Date setting
• Press “Snooze/Mode” key twice more after Clock mode can reach Date, Month and
Year setting
• Display method is Date – Month – Year
• Press “Hour” key to increment Month digit and “Min” key to increment Date digit and
“Year/Alarm” to increment Year digit.
• Weekday will change according to the setting of date, month and year
TIPS: Clock display modes HH:MM:SS or HH:MM + Weekday by pressing “Year/Alarm”
key
INSTALLATION OR WALL-MOUNTING
The base station
Choose a location for placing the base station, which is not exposed to sunlight.
Before final mounting of the base station, check if the unit is picking up a signal which is not being
impaired by parts of the building. If the signal is poor, choose a different place for mounting the
base station.
The notch on the back of the station allows you to mount the unit on the wall.
Place the base station on the stand supplied with the unit.
Sensor
Select a location for placement of the sensor, which is not exposed to direct sunlight or rain.
You may mount the sensor on a wall-mount unit or place it on a tabletop holder.
To set up the sensor, fold out the stand on the back of the holder.
Range
- Place the sensor within a radius of up to 30 m of the base station.
The reception range depends on the physical properties of the building where the base station is
used. Steel-reinforce walls, for example, reduce the reception range.
- Do not place it near the floor or ceiling, as this reduces the transmission range.
- At very low temperatures below freezing, the battery output may drop considerably and thus the
transmitting range may be temporarily reduced.
- Please bear in mind that the actual range of the sensors depends on the materials used in
constructing the building as well as where they are placed.
- Consider testing different locations.