User's Manual

4. Repeat Step (2) and Step (3) until all the data have been set.
5. The range of countdown display is from 1 second up to 23 hours 59 minutes and 59 seconds.
6. To start the countdown, press the ST/SP key in the Kitchen Countdown Timer mode or its setting mode. A beep
sound indicates that the countdown has started.
7. Press the ST/SP key during countdown will pause the process. To resume countdown, press the ST/SP key
again.
8. Countdown will continue even when you exit the Kitchen Countdown Timer mode.
9. When Countdown is finished, the display will jump to the Kitchen Countdown Timer mode and alarm sound
will be generated for 1 minute. Press any key to stop the alarm (Snooze Function: If the SNOOZE key is
pressed, the alarm sound will stop and re-generate after every 5 minutes until other key is pressed to stop the
alarm sound).
Local Temperature Display
1. With the built-in sensor, the local temperature of the Thermo Station will be displayed on the middle section.
2. The range of temperature display is between -25°C to +50°C with a resolution of 0.1°C. “HI” or “LO” will be
displayed if temperature is out of range.
3. To switch between °C and °F display, press the ST/SP key in the Clock mode.
4. To scroll through the displays of Current Temperature, Maximum Temperature, Minimum Temperature recorded
and Temperature alarm mode, press the SNOOZE key. “MAX” and “MIN” symbol will indicate the corresponding
mode. (Figure 5 and Figure 6)
5. To clear the records of Maximum and Minimum Temperature, press and hold the ST/SP key for 3 seconds. A beep
will sound and the data will be cleared. Both local and remote temperature data will be cleared.
Remote Temperature Display & Humidity Display (Optional) by RF-Technology (Frequency: 433MHz)
1. By RF technology, the Thermo Station can act as a Receiver and receive remote signals from up to 4 Remote
Transmitters (RT-101) which can be placed wherever you desire within the transmission range.
2. To enable the Thermo Station to receive signals from each Remote Transmitter, identical House code must be set
to all transmitters and different Channel numbers must be assigned to each Remote Transmitter in use. To achieve
this, please follow the procedures below to setup the Remote Transmitter(s) for use with the Thermo Station.
Remote Temperature Display
1. By using RF technology and simple Learn function, the Thermo Station can receive remote signals from up to 4
Remote Transmitters (WS260) which can be placed indoor / outdoor wherever you desire within the transmis-
sion range.
2. To enable the Thermo Station to receive signals from each Remote Transmitter, identical House Code and
different Channel Numbers must be assigned to each Remote Transmitter in use. Please follow the procedures
below to set the Remote Transmitter(s) to work with the Thermo Station.
Setting the Remote Transmitter(s)
1. There are 2 buttons at the back of transmitter. Press the RESET button (right side) to start the setting procedure.
2. House Code will be flashing with “01” as in Figure 7. If desired, press SET button (left side) to change the House
Code.
3. The range of House Code is from “01” to “15”. Make sure all transmitters in your system are set to the same House
Code.
4. The House Code will be confirmed if no key is pressed for 10 seconds. Channel Number will start to flash with “1”
as in Figure 8.