Install guide

12
Mouse ID
button
OPERATION
ID Setup
With the mouse positioned near the cradle
receiver/recharger, use a hard, narrow object
(such as a pin or a paper clip) to press both ID
buttons: rst on the cradle receiver/recharger;
then, within 10 seconds, on the underside of
the mouse. Hold each button in for a full second.
The cradle receiver/recharger light will ash
rapidly for a few seconds, then remain lit,
indicating that the connection between the
cradle receiver/recharger and the mouse has been made
and the mouse is ready for wireless operation.
Battery Charging
While using the mouse, if the red Low Battery LED on the mouse ashes,
recharge or change the batteries. To recharge, place the mouse in the
cradle of the receiver/recharger; a full charge requires 8-10 hours. To
stop charging, remove the mouse from the cradle.
To recharge the mouse when the computer is shut down, connect the
receiver/recharger base to a MANHATTAN powered USB hub.
NOTE: The actual charging time depends on the degree of the
discharge.
Functions
The function buttons
are indicated at right.
Scroll wheel
Left click
Right click
Page forward
Auto-scroll
Page back
Low Battery LED