User guide

To receive freesat you must
connect your Plaza HDR•S receiver
to an appropriate satellite dish,
xed in position and accurately
pointed at 28.2° East satellite
position.
For safety reasons and to
provide reliable reception, we
strongly recommend that the dish is
professionally installed. If you have
any questions about the dish, please
consult your installer.
2
CONNECT TO A DISH
Place your Plaza HDR•S receiver
on a firm, level surface close to your
television, a mains electricity socket,
and the cables from the dish.
Connect the cables from your
dish to the LNB IN 1 and LNB IN 2
sockets at the back of the receiver.
Make sure your television is turned
off and connect the HDMI cable to the
HDMI socket on the rear of the Plaza
HDR•S and to an HDMI socket on your
television. If you need more guidance,
check your television manual.
Connect the mains lead to the 2
pin mains connector on the external
power supply and connect the +12V
DC connector to the 3A DC 12V
connector at the back of the receiver.
Then connect the 3 pin mains plug to
an available mains socket.
3
PLUG IN
Remove the battery compartment cover from
the back of the Plaza HDR•S remote control
by pressing it gently while sliding it off. Insert
the two AAA batteries supplied, as shown on
the inside of the compartment. Replace the
compartment cover.
Turn on your TV set and choose the HDMI
input (see your television manual).
Switch on the mains socket the Plaza HDR•S
is connected to. After a few seconds, step
one of the freesat installation process will be
shown on the television screen.
If you do not see this screen (pictured
opposite), please refer to the Troubleshooting
section in the main user guide.
4
SWITCH ON
When the first installation screen is
displayed, use the
or buttons to select
the screen format of your television (16:9
Widescreen or the squarer 4:3 Traditional).
Press the
button to highlight the HDMI
Resolution selection box, and then use the
or
buttons to select the correct resolution
for your television (see your television’s
manual for guidance, or select 720p if unsure).
Press the button to highlight the “Next”
box and then press
again to display the
next installation step.
The signal check screen rst shows “Scanning”
for a few seconds. If it then shows that the
signal lock has “Failed”, see the Troubleshooting
section in the main user guide. When the signal
lock shows “Successful”, press
to display
the next installation screen.
Enter your postcode, pressing the number
buttons an appropriate number of times
to produce the letters (printed above each
button) and numbers required, in the same
way as ‘texting’ on a mobile phone. You do not
need to enter a space. If you make a mistake,
the button deletes the previous character.
Now press
once to confirm the postcode
and again to start the channel scan.
Your Plaza HDR•S receiver will take a couple of
minutes to find and store the freesat channels
available, displaying the total number of
freesat TV and radio channels found. Press the
button to display the next installation step.
Enter your choice of PIN (used to lock certain
channels and functions) by pressing the required
number button (0, 1 … 9) for each of the four PIN
digits. Press
to proceed to the next step.
Setup is now complete. Your PIN will be
displayed on-screen along with a reminder to
take a note of it. When ready, press and
enjoy watching freesat TV.
5
TUNE IN