Installation Instructions

15
PROBLEM POSSIBLE CAUSE WHAT TO DO
Your remote control
does not work
The T2•R is not turned on or
its front is obstructed.
Ensure the front of the receiver is not
obstructed.
Batteries are weak in the
remote control.
Replace batteries in the remote control.
Your T2•R switches
off after 3 hours
The T2•R is set to go to
standby by default after 3
hours without interaction.
Turn ‘Auto Standby’ off or select a different
duration in: Settings → System.
You can’t remember
your PIN
You’ve forgotten it or someone
has changed it.
Your PIN can be reset with the master PIN.
Please contact us.
You empty the trash
but available space
does not increase
Available space already
includes anything that is in
the trash
N/A
You programmed
your Manhattan
remote to control
your TV but the
volume seems low
You did not set the T2-R’s
volume to max before
programming your Manhattan
remote to control your TV.
• Reset your Manhattan remote by
holding the SUB and buttons for 3
seconds until the LED blinks
• Turn the volume up to max on your T2-R
• Reprogram your Manhattan remote to
control your TV (see p13)
The volume & mute
buttons on your
T2•R remote do
nothing
They have been programmed
to control the volume of
another device (see p13).
Reset your T2•R remote by following the
instructions in ‘Reset Your Remote’ on p13.
Loop Out does not
work in Standby
The “Loop Out in Standby”
setting is not turned on
Turn on ‘Loop Out in Standby’ in: Settings
→ System.
You can’t connect
your T2•R to the
internet to update
its software
It’s not possible to connect
your T2•R to an internet router
with an Ethernet cable
Software updates can be downloaded from
our website and installed using a USB stick.
When registering your T2•R you can choose
to be notified by email when updates are
released. Please contact us if you need help.