User Manual

26 Part Number 020003996 3/15
Operation Section 3
Component Identification
Splash
Panel
Counter
Merchandiser
Soda Valves
Key Switch
Carb/Non-Carb
Water Manifold
and Syrup/Soda
Inlet
(Behind Splash
Panel)
Drainpan Grid
Drainpan
Sequence of Operation
ICE RECOMMENDED FOR DISPENSING
Dispensers are designed to dispense hard, cube ice up to
one-inch square. The ice shapes and sizes listed below are
recommended for dispensing.
Warm “Super Cooled” Ice Before Dispensing: “Super Cooled”
ice is not recommended for dispensing. “Super cooled”
ice is ice that has been stored in freezers below 32°F. If it
is necessary to temporarily use “super cooled” ice, allow
the ice to warm at room temperature for 25 to 30 minutes
before placing the ice in the dispenser.
Recommended Ice
Other Ice Sizes And Shapes
Dice
7/8" x 7/8" x 7/8"
(2.2 x 2.2 x 2.2 cm)
Half Dice
3/8" x 1-1/8" x 7/8"
(1.0 x 2.9 x 2.2 cm)
Contour
3/8" x 1-1/4" x 1-1/4"
(1.0 x 3.2 x 3.2 cm)
Mini
7/8" Dia. x 3/4" Long
(2.2 cm Dia. x 1.9 cm Long)
Gourmet-Small
1" Dia. x 3/4"
(2.5 cm Dia. x 1.9 cm)
Crescent Cube
0.75"
(1.9 cm)
1.13"
(2.9 cm)
0.38"
(1.0 cm)
ICE STORAGE AND DISPENSING
As the customer presses the rocking chute, the arm at the
top left rear of the chute pushes upward on the door lock.
The door opens until it contacts the stops in the mounting
brackets. The plastic arm on the ice chute also activates
the lever of the ice dispensing switch. When activated, the
micro switch starts the gear motor. The gear motor turns
the paddle wheel and agitator arm.
The paddlewheel carries ice. Periodic agitation is standard
on the 30" and larger dispensers. During periodic agitation,
the paddle wheel and agitator turn for approximately three
seconds every three and one half-hours. The door lock
prevents ice from being dispensed during the agitation
cycle.
BEVERAGE VALVES
Post-mix beverage valves are designed to precisely meter
the flow of both water and syrup to obtain the proper
mixing ratio. The syrup and soda water components of the
post-mix beverage are mixed as they leave the beverage
valve.
ROCKING CHUTE ICE DISPENSING
As the customer presses the rocking chute, the arm at the
top left rear of the chute pushes upward on the door lock.
The door opens until it contacts the stops in the mounting
brackets. The plastic arm on the ice chute also activates
the lever of the ice dispensing switch. When activated, the
micro switch starts the gear motor. The gear motor turns
the paddle wheel and agitator bar.