User Manual

Part Number 020003996 3/15 35
Section 4 Maintenance
Preventative Maintenance
Preventative maintenance is a vital part of keeping your
dispenser in top condition. Following the guidelines below
will assist you in continued trouble-free operation of your
unit.
1. Conduct daily maintenance of the machine.
2. Perform monthly maintenance of the machine.
3. Perform periodic maintenance and sanitizing of
beverage system.
4. Do not overfill the dispenser bin with ice.
5. Do not allow the dispenser to sit for prolonged periods
of non-use with ice in the bin.
6. Most ice dispenser service problems are caused by low
usage of the ice dispenser.
7. Do not allow ice to remain in the bin more than a day
in order to prevent ice from freezing together and/or
stagnant ice.
Possible excess ice storage reasons:
• Storage capacity exceeds daily requirements.
• Low demand during the off-season.
• Dispenser oversized with future growth in mind.
Lower ice storage to meet one day’s needs. If you manually
fill ice, fill only with the appropriate amount of ice. Fill
the dispenser with fresh ice each morning. Do not fill the
dispenser at night just before shut down. Ice cubes can
freeze together if not dispensed.
Disassembly
DISASSEMBLY FOR CLEANING & MAINTENANCE
NOTE: Sanitize the ice dispenser at Initial Start-up in
addition to monthly sanitizing. You will need a slotted
screwdriver in order to disassemble.
Disassemble parts in the following order:
A. Merchandiser
B. Ice chute
C. Paddle wheel or agitator pins
D. Agitator
E. Paddle wheel
F. Bin liner
G. Paddle wheel area
A
G
F
E
C
D
B
Beverage/Ice Dispenser
Accessing a Dispenser Bin Top Mounted with a
Manitowoc Ice Machine:
1. Remove the front panel of the ice machine.
2. Remove the ice deflection baffle. This will give you
access to the dispenser bin.
3. If the Manitowoc ice machine is operating, wait for the
sheet of ice to fall into the dispenser bin, then place
toggle switch of the ice machine to the OFF position. If
the Manitowoc ice machine is NOT operating, place the
toggle switch of the ice machine to the OFF position
right away.
4. On models without a top mounted ice machine,
remove the plastic lid from the top of the dispenser.
5. Remove all ice from the dispenser.
6. Disconnect electrical power to the dispenser.